Extras are additional, flat-rate charges on a storage job, such as an after-hours access fee, storage admin fee, etc. These extra fees must be added to the invoice during the pricing process before any payment is accepted. Pricing cannot be changed after payment is accepted.

Extras are must be entered on a tab within each pricing template where they are needed. Once these extras are entered, they will be visible from the vehicle pricing screen.

1. Go to the vertical navigation pane and open “Configuration,” “Pricing setup,” and click on Pricing Templates.
2. See the template you want to add extras to from the Name column and click on it. Storage templates are highlighted in a light yellow color under the Existing Templates on the right-hand pane.
3. Also note that you can reorder columns of existing templates by click-and-hold on a heading and dragging into desired position.
4. Click on the “Extras” tab under pricing parameters.
5. Click on the green + “Add an extra to template” and begin typing your desired item to see if its been created. If so, select it and tab over to add a price. If it doesn't yet exist, click the other green+ “Make a new extra available” and then Add it to the template.
6. Be sure to add the price charged for the extra for the particular template.
7. Once all the Extras are added, click on the “Save” button in the top half of the page.

From Lot Management in RangerSST, for the MD Inside Storage pricing template, note the extras available from the Vehicle Pricing tab below exactly match those on the MD Inside Storage template above. This is because this MD Inside Storage template was selected by the lot attendant when admitting the vehicle into the lot. The Extras are attached to each storage pricing template under the “Extras” tab in pricing templates/pricing parameters.