Differences

This shows you the differences between two versions of the page.

--- support:07_storage-impound:01_lots [2015/09/30 08:43]
seyers
+++ support:07_storage-impound:01_lots [2015/10/26 09:31] (current)
seyers
@@ Line 1: / Line 1: @@
-====== Lots ======
+====== Configure Lots ======
-To set up and configure your lots in Ranger, from the left navigation pane, click on Lot Management, then Configure lots.
-When you reach the Company lot detail screen (see below),
+Configuring Lots in Ranger take just a few short steps:
+  - From Main Menu, go to left navigation pane/Lot management/Configure lots
+  - Enter a name for your lot(s), enter the complete address, and Save
+  - Create as many lots as you need.
+  - Dispatcher (or driver) can choose a lot as a tow destination, which inputs the address in Dispatch Direct.
+  - Vehicle automatically placed in Pending area in Lot Management.
-{{:support:07_storage-impound:configure_lots.png|}}
-  - Type the name of your lot (which will become available when entering a new job in Dispatch Direct) and complete the address, city, state and zip fields. Phone is optional but recommended.  Ranger fills in an Id and the GPS coordinates.
-  - If you do not use this lot as a base from which you dispatch, check the box "Exclude from closest base determination?"
-  - You will notice that Ranger finds the GPS coordinates for the new lot in the Latitude/Longitude fields.
-  - Click the save button at the bottom of the window.
-Click on the sliding pane from the right side of the pane to see your lots.  To add another lot, click the "Reset" button and repeat instructions above for each lot.

RangerSST Support Center

User Tools

Site Tools

Differences

Page Tools