User Tools
support:05_device_setup:apps:barcodescanner:barcodescanner
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
support:05_device_setup:apps:barcodescanner:barcodescanner [2014/09/19 10:47] jmather Add doorjamb notes |
support:05_device_setup:apps:barcodescanner:barcodescanner [2014/09/19 10:59] (current) jmather Fix formatting |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * In the "general settings" section, make sure that "use front light" is "off". The front light can make it harder to read barcodes. | * In the "general settings" section, make sure that "use front light" is "off". The front light can make it harder to read barcodes. | ||
| * In the "general settings:" section, make sure "use auto focus" is checked. | * In the "general settings:" section, make sure "use auto focus" is checked. | ||
| + | |||
| + | \\ | ||
| {{:support:05_device_setup:apps:barcodescanner:barcodescanner_settings1.png?300|}} {{:support:05_device_setup:apps:barcodescanner:barcodescanner_settings2.png?300|}} | {{:support:05_device_setup:apps:barcodescanner:barcodescanner_settings1.png?300|}} {{:support:05_device_setup:apps:barcodescanner:barcodescanner_settings2.png?300|}} | ||
| Line 24: | Line 26: | ||
| * Fading of the barcode | * Fading of the barcode | ||
| + | \\ | ||
| For best results, always scan the VIN barcode located in the vehicle doorjamb instead of the barcode on the front windshield. | For best results, always scan the VIN barcode located in the vehicle doorjamb instead of the barcode on the front windshield. | ||
| Line 31: | Line 34: | ||
| - Make sure the barcode is centered on the red "laser" line within the "clear" inner box. If the barcode is above the line, below the line, or crooked on the line, it might not scan. | - Make sure the barcode is centered on the red "laser" line within the "clear" inner box. If the barcode is above the line, below the line, or crooked on the line, it might not scan. | ||
| - While ensuring that both of the previous conditions are continuously met, SLOWLY move the mobile device closer then farther from the barcode in repeating fashion. The total range of motions is only about 6 inches. So, first move the device 3 inches closer to the barcode, then 3 inches back to neutral, then 3 inches further back, then 3 inches forward to neutral. Repeat until the scan occurs. | - While ensuring that both of the previous conditions are continuously met, SLOWLY move the mobile device closer then farther from the barcode in repeating fashion. The total range of motions is only about 6 inches. So, first move the device 3 inches closer to the barcode, then 3 inches back to neutral, then 3 inches further back, then 3 inches forward to neutral. Repeat until the scan occurs. | ||
| + | |||
| + | \\ | ||
| + | |||
| + | {{:support:05_device_setup:apps:barcodescanner:barcodescanner_vin_scan1.png?650|}} | ||
support/05_device_setup/apps/barcodescanner/barcodescanner.1411138044.txt.gz · Last modified: 2014/09/19 10:47 by jmather
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
